Frequently Asked Questions
Most clients see an immediate savings reduction between 10-30% and water usage by 3-6% The results vary by water pressure from the city water supply and valve size.
There are many ways air gets into the water supply as it travels though the pipes from your water supplier. Although water providers try to prevent outside air infusion, air is drawn into the water line in many ways such as during common main line breakages, pumps along the water line, small cracks or damaged joint seals and changes in temperature.
Most water meters measure volume passing through the meter so you are billed for the volume of water plus the air. The Flosaver Water Efficiency Valve compresses the air in the pipe as it goes through the meter so you are billed only for water, not water plus air bubbles. This results in up to 30% reduction in water costs.
No. Your Flosaver Valve is installed on the property side of the meter.
Flosaver Valve is manufactured in sizes from 1″ to 16″
We can also build custom Flosaver Valves in sizes up to 36 inches
Flosaver Water Efficiency Valve is typically installed in under an hour per valve, and many times in only 30 minutes. Installation can be scheduled during hours that don’t interrupt your schedule or business.
Yes, however Flosavers recommends a licensed plumber or mechanical contractor install the valve.
The water coming from the city is often over-pressurized, causing you to use more water than necessary. Lower water pressure is desirable and typically not enough that guests or customers notice. In most instances the pressure drop is between 6 to 8 psi.
You will know the Flosaver Water Efficiency Valve is working because you’ll see an immediate reduction in your volume usage, and a lower water bill.
The Flosaver Water Efficiency Valve is manufactured in the USA.